![]() This will disable the secure port, if any other device other than the one with the above MAC-Address connects to the switch port. Where 1111.2222.3333 is the MAC Address of the server. Switchport(config-if)# switchport port-security mac-address 1111.2222.3333 If you know the MAC Address of the device and that thats the only device that connects to the swicthport (for example, A server on a Serverfarm switch) then you can set the MAC-Address manually. This enables the port security on the switchport with the defaults Switch(config-if)# switchport port-security Default mode of "Dynamic desirable" cannot be configured as a secure port Switch(config-if)# switchport mode access Switch(config)# interface fastethernet 0/1 To enable Port Security on a Cisco Switch or router interfaceĮnter the interface config mode (say fa0/1) ![]() If you try to change an 802.1X-enabled port to a secure port, an error message appears, and the security settings are not changed. If you try to enable 802.1X on a secure port, an error message appears, and 802.1X is not enabled. the switchport cannot be an 802.1X port.the switchport cannot belong to an EtherChannel port-channel interface.the switchport cannot be a destination port for a Switchport Analyzer (SPAN).Action to take when there is a violation detected (default is to disable the port and send an SNMP Trap message to the SNMP management server (if any))įor a switch port to be security enabled,.set aging in minutes of the MAC Addresses registed.restrict the number of MAC-Addresses that can connect through a switchport. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |